LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1415 (Engine Control System - 4.2L (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new O-ring on the camshaft position actuator solenoid.
  2. Lubricate the hole (1) with engine oil.
    3. Fig 1: View Of CMP Actuator Solenoid Valve
    GM744600Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the camshaft position actuator solenoid (2) and bolt (3).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Connect the camshaft position actuator solenoid electrical connector.
  5. Install the power steering pump and bolts. Refer to Power Steering Pump Replacement (5.3L) or Power Steering Pump Replacement (4.2L) in Power Steering Systems.
  6. Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
scientia non olet · About LEMON Manuals