LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Trim Plate Replacement - Rear Floor - Front >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the midgate to the cargo position.
  2. Raise the hinged filler panel on the back of the midgate.
    3. Fig 1: Removing/Installing Pushpins Securing Rear Floor Front Trim Panel End Covers
    GM1236706Courtesy of GENERAL MOTORS CORP.
  3. Remove the pushpins securing the rear floor front trim panel end covers by unscrewing the retainer pin.
  4. Remove the rear floor front trim panel end covers.
  5. Remove 2 push pin fasteners by lifting up on each end of the rear floor front trim panel.
    6. Fig 2: Removing/Installing Rear Floor Front Trim Panel
    GM1236713Courtesy of GENERAL MOTORS CORP.
  6. Grasp the front edge of the rear floor front trim panel and pull straight up to release the retaining clips along the front edge.
  7. Remove the rear floor front trim panel by pulling straight up to release the retaining clips along the rear edge.
  8. Remove the rear floor front trim panel from the vehicle
scientia non olet · About LEMON Manuals