LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Trim Plate Replacement - Rear Floor - Front >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Rear Floor Front Trim Panel
    GM1236713Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the retaining clips are securely installed on the back side of the rear floor front trim panel.
  2. Lift up on the front edge of the cargo mat and slide the rear floor trim panel into position.
  3. Position the rear floor front trim panel so that the fasteners align with their respective holes.
  4. Install the rear floor front trim panel by pressing the retaining clips and fasteners into the sheet metal openings.
    5. Fig 2: Removing/Installing Pushpins Securing Rear Floor Front Trim Panel End Covers
    GM1236706Courtesy of GENERAL MOTORS CORP.
  5. Install the rear floor front trim panel end covers by pressing them in place.
  6. Install the pushpin in each rear floor front trim panel end cover by pushing the pin into the hole and screwing in the retainer pin.
scientia non olet · About LEMON Manuals