LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Body Side (Envoy XUV) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cargo mat. Refer to Cargo Mat Replacement (Envoy XUV) in Body Rear End.
  2. Remove the body lock pillar upper tie bar trim cover. Refer to Trim Cover Replacement - Body Lock Pillar Upper Tie Bar - Cargo (Envoy XUV) .
  3. Remove the rear floor front trim plate. Refer to Trim Plate Replacement - Rear Floor - Front .
    4. Fig 1: Removing/Installing Cargo Tie Down Loops & Cargo Tie Down Blanks
    GM1244994Courtesy of GENERAL MOTORS CORP.
  4. Remove the cargo tie down loops and the cargo tie down blanks.
  5. Remove the cargo lamp. Refer to Cargo Lamp Replacement (Envoy XUV) in Lighting Systems.
  6. Remove the endgate window emergency switch, if equipped. Refer to Switch Replacement - Endgate Window Interior Emergency in Body Rear End.
    7. Fig 2: Removing/Installing Trim Panel - Body Side (Envoy XUV)
    GM1236692Courtesy of GENERAL MOTORS CORP.
  7. Remove the auxiliary power outlet from the trim panel, if equipped. Refer to Accessory Power Receptacle Replacement - 12 Volt in Power Outlets.
  8. Remove the body side trim panel from the vehicle.
scientia non olet · About LEMON Manuals