Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Jack & Tool Stowage Container Bracket (Envoy XUV)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Remove the jack bracket to the floor studs with the retaining nuts (1).
Tighten: Tighten the jack bracket nuts to 10 N.m (88 lb in).
Remove the tool package (4) to the jack bracket with nut (3). Do not overtighten the nut.
Install the jack stowage cover. Refer to Cover Replacement - Jack Stowage (Envoy XUV) .