LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Windshield Pillar >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Garnish Molding - Windshield Pillar
    GM714026Courtesy of GENERAL MOTORS CORP.
  1. Starting at the top of the garnish molding, carefully release the upper attaching clip that retains the garnish molding to the first pillar.
  2. Release the remaining 2 retaining clips from the first pillar.
  3. Remove the garnish molding (1) from the vehicle.
scientia non olet · About LEMON Manuals