LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Rear Window >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
    2. Fig 1: Removing Wire Harness From Slot Located On Garnish Molding
    GM721365Courtesy of GENERAL MOTORS CORP.
  2. Release the clips that retain the garnish molding to the liftgate.
  3. Remove the wire harness (1) from the slot located on the garnish molding.
  4. Remove the garnish molding from the liftgate.
scientia non olet · About LEMON Manuals