LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Rear Window >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wire Harness To Slot Located On Garnish Molding
    GM721365Courtesy of GENERAL MOTORS CORP.
  1. Position the garnish molding to the liftgate.
  2. Install wire harness (1) into the slot located on the garnish molding.
  3. Index the locating tabs to the corresponding holes in the liftgate.
  4. Index the retaining clips to the liftgate.
  5. Push the garnish molding into the liftgate in order to fully seat the retaining clips.
  6. Close the liftgate.
scientia non olet · About LEMON Manuals