LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Center Pillar >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Garnish Molding (Center Pillar)
    GM740434Courtesy of GENERAL MOTORS CORP.
  1. Remove the front and rear door sill plates. Refer to Door Sill Plate Replacement - Front  and Door Sill Plate Replacement - Rear (TrailBlazer, Envoy, Bravada)  or Door Sill Plate Replacement - Rear (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  2. Move the seat to a forward position.
  3. Release the 4 retaining clips that attach the garnish molding to the center pillar.
  4. Disconnect the electrical connector from the temperature sensor, if equipped.
  5. Remove the garnish molding from the vehicle.
scientia non olet · About LEMON Manuals