LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Body Side Window - Front (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the garnish molding to the vehicle.
    Fig 1: Identifying Garnish Molding - Body Side Window - Front (TrailBlazer EXT, Envoy XL)
    GM798350Courtesy of GENERAL MOTORS CORP.
  2. Install the seat belt retractor to the body.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt that retains the seat belt anchor to the body.

    Tighten:  Tighten the anchor bolt to 70 N.m (52 lb ft).

scientia non olet · About LEMON Manuals