LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Carpet Replacement - Rear (TrailBlazer EXT, Envoy XL) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seats. Refer to Seat Replacement - Front Bucket in Seats.
  2. Remove the second row rear seats. Refer toSeat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) in Seats.
  3. Remove the third row rear seats. Refer to Seat Replacement - Rear No. 2 in Seats.
  4. Remove the front door sill plates. Refer to Door Sill Plate Replacement - Front .
  5. Remove the rear door sill plates. Refer to Door Sill Plate Replacement - Rear (TrailBlazer, Envoy, Bravada)  or Door Sill Plate Replacement - Rear (TrailBlazer EXT, Envoy XL, Envoy XUV) .
    6. NOTE: Remove the headliner and the headliner harness as an assembly. Do NOT cut or splice the headliner harness. Cutting or splicing the harness may damage the coax cable, resulting in poor radio performance.
  6. Remove the center pillar trim panels. Refer to Garnish Molding Replacement - Center Pillar .
  7. Remove the lift gate door sill plate. Refer to Door Sill Plate Replacement - Liftgate .
  8. Remove the left/right front body side window garnish molding. Refer to Garnish Molding Replacement - Body Side Window - Front (TrailBlazer EXT, Envoy XL) .
  9. Remove the left/right rear body side window garnish molding. Refer to Garnish Molding Replacement - Body Side Window - Rear (TrailBlazer EXT, Envoy XL) .
    10. Fig 1: Identifying Stowage Jack Carrier To Wheelhouse Panel Nut
    GM798354Courtesy of GENERAL MOTORS CORP.
  10. Remove the bolts from the cargo tie-down loops.
  11. Remove the nut (1), securing the stowage jack carrier to the wheelhouse panel.
  12. Loosen the three bolts that secure the jack carrier to the vehicle.
  13. Remove the carpet from around the wheel stud.
  14. Remove the body electrical block. Refer to Rear Electrical Center or Junction Block Replacement in Wiring Systems.
  15. Remove the body electrical block electrical connectors back through the hole in the carpet.
  16. Pull the communication interface module electrical connectors back through the hole in the carpet.
    17. Fig 2: Identifying Console Floor Bracket
    GM741605Courtesy of GENERAL MOTORS CORP.
  17. Remove the floor console to the floor console carrier. Refer to Console Replacement in Instrument Panel, Gages and Console.
  18. Remove the 4 nuts (2) retaining the rear of the floor console bracket to the floor weld studs.
  19. Raise the rear portion of the floor console bracket and remove the carpet from underneath the console bracket.
  20. Remove the carpet from the vehicle.
scientia non olet · About LEMON Manuals