LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Interior Trim) >> Repair Instructions >> Carpet Replacement - Rear (Envoy XUV) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Carpet - Rear (Envoy XUV)
    GM1243209Courtesy of GENERAL MOTORS CORP.
  1. Remove the front seats. Refer to Seat Replacement - Front Bucket in Seats.
  2. Remove the rear seats. Refer toSeat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) in Seats.
  3. Remove the front door sill plates. Refer to Door Sill Plate Replacement - Front .
  4. Remove the rear door sill plates. Refer to Door Sill Plate Replacement - Rear (TrailBlazer, Envoy, Bravada)  or Door Sill Plate Replacement - Rear (TrailBlazer EXT, Envoy XL, Envoy XUV) .
    5. NOTE: Remove the headliner and the headliner harness as an assembly. Do NOT cut or splice the headliner harness. Cutting or splicing the harness may damage the coax cable, resulting in poor radio performance.
  5. Remove the center pillar trim panels. Refer to Garnish Molding Replacement - Center Pillar .
  6. Remove the rear floor trim panel. Refer to Trim Cover Replacement - Rear Floor Trim Panel .
  7. Remove the left/right lower body lock pillar trim panel. Refer to Trim Panel Replacement - Body Lock Pillar Lower (Envoy XUV) .
  8. Remove the jack and tool stowage bracket. Refer to Jack and Tool Stowage Container Bracket Replacement (Envoy XUV) .
  9. Remove the rear seat & mid-gate rest. Refer to Rest Replacement - Rear Seat and Midgate in Seats.
  10. Remove the body electrical block. Refer to Rear Electrical Center or Junction Block Replacement in Wiring Systems.
  11. Remove the body electrical block electrical connectors back through the hole in the carpet.
  12. Pull the communication interface module electrical connectors back through the hole in the carpet.
    13. Fig 2: Identifying Console Floor Bracket
    GM741605Courtesy of GENERAL MOTORS CORP.
  13. Remove the floor console to the floor console carrier. Refer to Console Replacement in Instrument Panel, Gages and Console.
  14. Remove the 4 nuts (2) retaining the rear of the floor console bracket to the floor weld studs.
  15. Raise the rear portion of the floor console bracket and remove the carpet from underneath the console bracket.
  16. Remove the carpet from the vehicle.
scientia non olet · About LEMON Manuals