LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Engine Controls Self-Diagnostics - 5.7L - Bi-Fuel) >> Diagnostic Tests >> DTC P0601: AF ECM Memory >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
  2. Replace AF ECM. See ALTERNATE FUEL ENGINE CONTROL MODULE under COMPUTERIZED ENGINE CONTROLS in REMOVAL, OVERHAUL & INSTALLATION - CHEVY EXPRESS & SAVANA - BI-FUEL. Program (flash) AF ECM with correct vehicle software and calibration. See ALTERNATE FUEL ENGINE CONTROL MODULE  under PROGRAMMING. After performing repairs and procedures, go to next step.
  3. Reconnect all disconnected components and connectors. Using scan tool, clear DTCs for PCM and AF ECM. Start engine and allow to idle until engine reaches normal operating temperature. Select DTC and specific DTC function. Enter DTC number and operate vehicle, within Conditions For Setting DTC, until scan tool indicates diagnostic has run. If DTC diagnostic runs and passes, system is okay. If DTC resets, go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
scientia non olet · About LEMON Manuals