LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1408 (Entertainment System) >> Diagnostic Information and Procedures >> DTC B1025, B1035, B1045, or B1055 >> Conditions for Clearing the DTC

Conditions for Clearing the DTC

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The fault condition is not present for 5 seconds.

DTC B1025, B1035, B1045, or B1055

Step Action Yes No
Schematic Reference: Radio/Audio System Schematics 
1 Did you perform the Entertainment System Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Entertainment System 
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool, monitor the DTC Information for DTC B1025, B1035, B1045 or B1055.
Does the scan tool indicate that DTC B1025, B1035, B1045 or B1055 is current?
Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3 Test the speaker outputs from the radio for short to ground or voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 6  Go to Step 4 
4 Inspect for poor connections at the harness connector of the radio. Refer toTesting for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 6  Go to Step 5 
5
IMPORTANT: Reprogram the radio. Refer to Service Programming System (SPS) in Programming.
Replace the radio. Refer to Radio Replacement  .Did you complete the replacement?
Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2