LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1407 (Door System, Mirror System & Window System) >> Repair Instructions >> Window Weatherstrip Run Channel Assembly Replacement - Rear (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Window Weatherstrip Run Channel Assembly - Rear (TrailBlazer, Envoy, Bravada)
    GM690972Courtesy of GENERAL MOTORS CORP.
  1. Install the weatherstrip/run channel to the door.
  2. Press the weatherstrip/run channel into the window frame opening.
  3. Position the tabs on the weatherstrip/run channel into the slots on the door.
  4. Attach the molding to the outside of the door with double sided tape.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the weatherstrip/run channel retaining bolt.

    Tighten:  Tighten the bolt to 10 N.m (88 lb in).

  6. Install the window. Refer to Window Replacement - Rear Door (TrailBlazer EXT, Envoy XL)  or Window Replacement - Rear Door (TrailBlazer, Envoy, Bravada) .
  7. Install the water deflector. Refer to Water Deflector Replacement - Rear Door .
  8. Install the outer window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer .
  9. Install the inner window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner .
  10. Install the trim panel. Refer to Trim Panel Replacement - Side Rear Door .
scientia non olet · About LEMON Manuals