Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Lift up on the front edge of the switch panel in order to release the front retaining clip.
- Lift up on the rear edge of the switch panel in order to release the 2 rear retaining clips.
- If equipped, disconnect the electrical connectors from the passenger door module (1).
- If replacing only the passenger door module, remove the module from the door trim panel.
- Disconnect the remaining electrical connectors from the switch panel.
- If replacing only the switch panel, retain the passenger door module for transfer.
- Remove the switch panel assembly from the vehicle.