LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1407 (Door System, Mirror System & Window System) >> Repair Instructions >> Door Handle Replacement - Front Outside >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Close the window to the full up position.
  2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door .
    3. Fig 1: Removing/Installing Door Handle - Front Outside
    GM730435Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear half of the water deflector from the door.
  4. Release the upper lock rod retainer (1) from the rod.
  5. Remove the lock rod from the handle assembly.
  6. Release the lock cylinder rod retainer (2) from the lock rod, if equipped.
  7. Remove the lock cylinder rod from the handle assembly, if equipped.
  8. Remove the 2 door handle retaining nuts.
  9. Remove the handle assembly from the door.
  10. Remove the lock cylinder from the handle, if equipped. Refer to Lock Cylinder Replacement - Door .
scientia non olet · About LEMON Manuals