LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1406 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Envoy, TrailBlazer, Rainier, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Lower the rear portion of the headliner by releasing the 2 headliner retaining pins.
  3. Disconnect the high mount stop lamp electrical connector (2).
    Fig 1: Accessing High Mount Stop Lamp Electrical Connector (Envoy, TrailBlazer, Rainier, Bravada)
    GM721363Courtesy of GENERAL MOTORS CORP.
  4. Remove the grommet (1) from the body.
    5. NOTE: Do NOT raise the liftgate while the liftgate glass is open. This can result in damage to the high-mounted stoplamp, the liftgate hinges, or the liftgate glass.
  5. Close the liftgate.
  6. Open the liftgate window.
    7. Fig 2: Removing/Installing High Mount Stop Lamp (Envoy, TrailBlazer, Rainier, Bravada)
    GM732876Courtesy of GENERAL MOTORS CORP.
  7. Remove the 2 screws that retain the high mount stoplamp to the lift gate window reveal molding.
  8. Remove the high mount stop lamp from the vehicle.
scientia non olet · About LEMON Manuals