LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1406 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Envoy XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the high mounted stop lamp to the end gate reveal molding.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 3 nuts that retain the high mounted stop lamp to the reveal molding.

    Tighten:  Tighten the nuts to 2.5 N.m (22 lb in).

  3. Install the end gate window reveal molding. Refer to Molding Window Reveal Replacement - Endgate in Exterior Trim.
scientia non olet · About LEMON Manuals