LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1406 (Lighting Systems) >> Diagnostic Information and Procedures >> Vanity Mirror Lamp(s) Inoperative

Vanity Mirror Lamp(s) Inoperative

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Vanity Mirror Lamp(s) Inoperative Diagnostic Test

Step Action Yes No
Schematic Reference:  Interior Lights Schematics  
Connector End View Reference:  Lighting Systems Connector End Views  
1 Did you perform the Lighting Systems Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2 Verify that the visor vanity mirror lamps are inoperative.
Do the visor vanity mirror lamps operate normally?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Connect a test lamp from the inadvertent power courtesy lamps supply voltage circuit above the headliner at the inoperative visor vanity mirror connector to ground. Refer to Circuit Testing in Wiring Systems.
Does the test lamp illuminate?
Go to Step 4  Go to Step 5 
4 Connect a test lamp between the inadvertent power courtesy lamps supply voltage circuit and the ground circuit at the inoperative visor vanity mirror lamp connector. Refer to Circuit Testing in Wiring Systems.
Does the test lamp illuminate?
Go to Step 7  Go to Step 6 
5 Repair the open, high resistance or short to ground in the inadvertent power courtesy lamps supply voltage circuit. Refer to Wiring Repairs in Wiring Systems.
Is the repair complete?
Go to Step 8  -
6 Repair the open or high resistance in the ground circuit. Refer to Wiring Repairs in Wiring Systems.
Is the repair complete?
Go to Step 8  -
7 Is the repair complete? Go to Step 8  -
8 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3