LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1406 (Lighting Systems) >> Diagnostic Information and Procedures >> Daytime Running Lamps (DRL) Defeat Inoperative

Daytime Running Lamps (DRL) Defeat Inoperative

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Daytime Running Lamps (DRL) Defeat Inoperative Diagnostic Test

Step Action Yes No
Schematic Reference:  Headlights/Daytime Running Lights (DRL) Schematics  
Connector End View Reference:  Lighting Systems Connector End Views   or  Body Control System Connector End Views  in Body Control System
1 Did you perform the Lighting Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2 Verify that the Daytime Running Lamps (DRL) defeat feature of the headlamp switch operates properly.
Do the DRL headlamps turn OFF when the defeat mode is applied?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Ensure that the automatic headlamps are in the DRL mode.
  2. Disconnect the headlamp switch.
  3. Momentarily connect a fused jumper wire between the DRL defeat switch signal circuit and the ground circuit of the headlamp switch IP harness connector.
Do the DRL turn OFF or ON?
Go to Step 6  Go to Step 4 
4 Test for an open, high resistance, short to ground, or short to voltage in the DRL defeat switch signal circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct a condition?
Go to Step 9  Go to Step 5 
5 Inspect for poor connections at the harness connector of the Body Control Module (BCM). Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 7 
6 Inspect for poor connections at the harness connector of the headlamp switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 8 
7
IMPORTANT: Perform the setup procedure for the BCM.
Replace the body control module (BCM). Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?
Go to Step 9  -
8 Replace the headlamp switch. Refer to Headlamp Switch Replacement .
Did you complete the replacement?
Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3