LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1406 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B2610: Passenger Compartment Dimming 1 Circuit >> Test Description

Test Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step test determines by process of elimination which, if any, dimmable component is causing the DTC to set.
  2. 3:  This step test determines if the problem exists in the wiring or the BCM.
  3. 5:  After replacement of the BCM you must calibrate the new module for proper operation.
DTC B2610 Diagnostic Test

Step Action Yes No
Schematic Reference:  Interior Lights Dimming Schematics  
Connector End View Reference:  Lighting Systems Connector End Views   or  Body Control System Connector End Views  in Body Control System
1 Did you perform the Lighting System Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2 
  1. Clear the DTC B2610 with the scan tool.
  2. Turn the park lamps ON.
  3. Adjust the I/P dimmer switch to a mid range dimming position.
  4. Disconnect each dimmable component from the instrument panel lamps dimming control circuit, one at a time, while monitoring the scan tool current codes.
Does DTC B2610 not reset after a particular dimmable component was disconnected?		 Go to Step 4  Go to Step 3 
3  Test the instrument panel lamps dimming control circuit for an open, high resistance, short to voltage or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 6  Go to Step 5 
4 Replace the dimmable component associated with when the code did not reset. Refer to the proper replacement procedure for that particular component.
Did you complete the repair?		 Go to Step 6  -
5 
IMPORTANT: Perform the setup procedure for the BCM.
Replace the body control module (BCM). Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?		 Go to Step 6  -
6
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals