Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Verify all primers and urethane adhesive are within expiration dates.
- Use a new dauber in order to apply glass prep, clear #1, to the channel area approximately 13 mm (1/2 in) to the upper edge of the window.
- Wipe the glass primed area immediately with a clean lint-free cloth.
- Shake the glass primer, black #2, for at least 1 minute.
- Use a new dauber in order to apply glass primer, black #2, to the top edge of the window.
- Apply a small bead of urethane adhesive (2) between the window (1) and the pinch-weld.
- Reinstall the window reveal molding.
- Start from the loose area and hand-press the reveal molding into place over the edge of the window.
- Run warm water over the reveal molding in order to speed the setup time of the urethane adhesive.
- Tape should be applied in order to retain the reveal molding to the window. This will maintain a flush fit with the body.
- The tape is to be removed after 6 hours.
CAUTION:
Refer to Window Retention Caution in Cautions and Notices.
IMPORTANT:
Use care when applying the prep, clear #1, to the window. This primer dries almost instantly, and may stain the viewing area of the window if not applied evenly.