Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

Open the end gate window.

Fig 1: Upper Rear Roof Applique

Courtesy of GENERAL MOTORS CORP.

Remove the upper rear roof applique. Refer to Applique Replacement - Roof Rear in Exterior Trim.

Fig 2: Separating Urethane Adhesive From Window

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.

IMPORTANT: Keep the cutting edge of the tool against the window. Do this from inside the vehicle.

This will allow the urethane adhesive to be separated from the window.
- Leave a base of urethane on the pinch-weld flange.
- The only suitable lubrication is clear water.
- UseJ 39032 or equivalent in order to remove the window.

Fig 3: Removing/Installing Quarter Window

Courtesy of GENERAL MOTORS CORP.

With the aid of an assistant, remove the quarter window (3) from the opening.