LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1404 (Stationary Window System) >> Repair Instructions >> Quarter Window Replacement (XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Quarter Window
    GM1231053Courtesy of GENERAL MOTORS CORP.
  1. Install the body side stationary window (3) into the opening. Refer to Urethane Adhesive Installation of Bodyside Stationary Windows (W/Frame) Urethane Adhesive Installation of Bodyside Stationary Windows (W/O Frame) .
  2. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
    3. Fig 2: Upper Rear Roof Applique
    GM1347082Courtesy of GENERAL MOTORS CORP.
  3. Install the upper rear roof applique. Refer to Applique Replacement - Roof Rear in Exterior Trim.
  4. Inspect the radio or the OnStar® system, if equipped, to verify reception.
  5. Close the end gate window.
scientia non olet · About LEMON Manuals