LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1403 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive Cable Replacement (4.2L Engine) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
    2. Fig 1: Identifying Battery Cable Components
    GM899613Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the battery positive cable (4) from the battery.
    3. Fig 2: View Of Positive Cable Lead At Junction Block
    GM759304Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the positive cable lead from the junction block (1).
  4. Disconnect the battery cable conduit from the conduit retaining clip.
  5. Remove the battery positive cable from the conduit.
  6. Remove the battery positive cable harness from the fir-tree retainer on the powertrain control module (PCM) bracket.
    7. Fig 3: View Of Starter & Related Components
    GM754358Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the positive cable lead from the starter (1).
    8. Fig 4: Rear Of Generator (Alternator) View
    GM754357Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the positive cable lead from the generator (1).
  9. Remove the battery positive cable from the vehicle.
scientia non olet · About LEMON Manuals