Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Oldsmobile, Buick) .

Fig 1: Removing/Installing Trim Plate - Instrument Panel (I/P) Accessory (Oldsmobile/Buick)

Courtesy of GENERAL MOTORS CORP.

Remove the lower trim plate retaining screws.
Starting at the bottom of the trim plate, release the 2 lower retaining clips and the 2 intermediate retaining clips.
Release the 3 upper retaining clips.
Disconnect the electrical connectors as necessary.
If replacing the trim plate, perform the following steps:
1. Remove the rear windshield wiper switch. Refer to Wiper/Washer Switch Replacement - Rear in Wiper/Washer Systems.
2. If equipped, remove the cigar lighter and 12-volt power supply. Refer to Accessory Power Receptacle Replacement - 12 Volt in Power Outlets.