LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center console. Refer to Console Replacement .
  2. Remove the center lower closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower (GMC/Chevrolet) .
    3. Fig 1: Removing/Installing Trim Plate - Instrument Panel (I/P) Accessory (GMC)
    GM712822Courtesy of GENERAL MOTORS CORP.
  3. Remove the lower trim plate retaining screws.
  4. Starting at the bottom of the trim plate, release the 2 lower retaining clips and the 2 intermediate retaining clips.
  5. Release the 3 upper retaining clips.
  6. Disconnect the electrical connectors as necessary.
  7. If replacing the trim plate, perform the following steps:
    1. If equipped, remove the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement (GMC, Buick) or Transfer Case Shift Control Switch Replacement (Chevrolet) .
    2. Remove the rear windshield wiper switch. Refer to Wiper/Washer Switch Replacement - Rear in Wiper/Washer Systems.
    3. If equipped, remove the cigar lighter and 12-volt power supply. Refer to Accessory Power Receptacle Replacement - 12 Volt in Power Outlets.
scientia non olet · About LEMON Manuals