LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Panel Replacement - Knee Bolster >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Knee Bolster Trim Panel
    GM712827Courtesy of GENERAL MOTORS CORP.
  1. Position the trim panel to the IP.
  2. Seat the clips that retain the trim panel to the IP.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 4 trim panel retaining screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals