Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the windshield pillar garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.

Fig 1: Removing/Installing Trim Pad - Instrument Panel (I/P) Upper

Courtesy of GENERAL MOTORS CORP.

Starting at the outboard edges, release the trim pad retaining clips.

Fig 2: Removing/Installing Ambient Light Sensor

Courtesy of GENERAL MOTORS CORP.

Rotate the ambient light sensor counter-clockwise 1/4 turn in order to release the sensor from the trim pad.
Remove the trim pad from the vehicle.

IMPORTANT: Cover the windshield defrost vents with clean shop rags.

Disconnect the electrical connector from the ambient light sensor and retain the sensor for installation.