LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Pad Replacement - Instrument Panel (I/P) Upper >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Ambient Light Sensor
    GM729432Courtesy of GENERAL MOTORS CORP.
  1. In order to install the ambient light sensor to the trim pad, rotate the sensor clockwise 1/4 turn ensuring the retaining tabs are fully seated.
    2. Fig 2: View Of Instrument Panel (I/P) Upper Trim Pad
    GM718025Courtesy of GENERAL MOTORS CORP.
  2. Position the trim pad to the IP.
  3. Connect the electrical connector to the ambient light sensor.
  4. Remove the shop rags from the windshield defrost vents.
    5. Fig 3: Removing/Installing Trim Pad - Instrument Panel (I/P) Upper
    GM712816Courtesy of GENERAL MOTORS CORP.
  5. Align the locating stems to the IP substrate.
  6. Install the trim pad by seating the retaining clips to the IP substrate.
  7. Install the windshield pillar garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
scientia non olet · About LEMON Manuals