LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Knee Bolster
    GM712844Courtesy of GENERAL MOTORS CORP.
  1. Install the knee bolster to the steering column support bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 knee bolster retaining nuts.

    Tighten:  Tighten the nuts to 10 N.m (88 lb in).

  3. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  4. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals