LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
  2. Remove the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  3. Remove the instrument panel cluster (IPC) bezel, Chevrolet only. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet)  or Bezel Replacement - Instrument Panel (I/P) Cluster (GMC/Oldsmobile/Buick) .
  4. Remove the instrument panel (I/P) accessory trim plate, GMC or Oldsmobile only. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC)  or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Oldsmobile/Buick) .
    5. Fig 1: Removing/Installing Instrument Panel Cluster (IPC)
    GM692029Courtesy of GENERAL MOTORS CORP.
  5. Remove the screws retaining the IPC to the I/P.
  6. Partially remove the IPC from the I/P in order to gain access to the electrical connector.
  7. Disconnect the electrical connector from the IPC.
  8. Remove the IPC from the I/P.
scientia non olet · About LEMON Manuals