LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Instrument Panel Cluster (IPC)
    GM692029Courtesy of GENERAL MOTORS CORP.
  1. Position the IPC to the I/P.
  2. Connect the electrical connector to the IPC.
  3. Install the IPC to the I/P.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws to the instrument panel cluster.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  5. Install the instrument panel (I/P) accessory trim plate, GMC or Oldsmobile only. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC)  or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Oldsmobile/Buick) .
  6. Install the instrument panel cluster (IPC) bezel, Chevrolet only. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet)  or Bezel Replacement - Instrument Panel (I/P) Cluster (GMC/Oldsmobile/Buick) .
  7. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  8. Install the left closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
  9. If installing a new IPC. Refer to Service Programming System (SPS) in Programming.
scientia non olet · About LEMON Manuals