LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel (I/P) Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing the I/P, install the air distribution duct vents to the instrument panel. Refer to Air Distributor Duct Replacement in HVAC.
  2. If replacing the I/P, install the passenger inflatable restraint module to the instrument panel. Refer to Inflatable Restraint Instrument Panel Module Replacement in SIR.
  3. With the aid of an assistant, install the instrument panel to the vehicle.
    4. IMPORTANT: Ensure the wiring harnesses and electrical connectors are not pinched behind the instrument panel and are positioned for proper connection.
  4. Fully seat the instrument panel to the positioning locators.
    5. Fig 1: Removing/Installing Bolts Securing Middle & Upper Portion Of Instrument Panel To Vehicle
    GM713403Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not tighten the I/P retaining bolts until all of the bolts have been loosely installed.
  5. Install the bolts securing the middle and upper portion of the instrument panel to the vehicle.
    6. Fig 2: Removing/Installing Bolts Securing Lower Portion Of Instrument Panel To Vehicle
    GM713401Courtesy of GENERAL MOTORS CORP.
  6. Install the bolts that secure the lower portion of the instrument panel to the vehicle.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Complete the installation of all of the bolts that retain the I/P to the vehicle.

    Tighten:  Tighten the bolts to 7 N.m (62 lb in).

    8. Fig 3: Removing/Installing Side Window Defogger Outlet Screw
    GM759088Courtesy of GENERAL MOTORS CORP.
  8. Install the side window defogger outlet screw.

    Tighten:  Tighten the screw to 2.5 N.m (22 lb in).

    9. Fig 4: Identifying Right I/P Access Cover
    GM712793Courtesy of GENERAL MOTORS CORP.
  9. Install the right I/P access cover.
  10. Install the front upper speakers, if equipped. Refer to Speaker Replacement - Front Upper in Entertainment.
  11. Install the trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper .
  12. Install the windshield garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
  13. If replacing the I/P, Install the headlamp switch bezel. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory Left .
  14. Install the headlamp switch to the bezel. Refer to Headlamp Switch Replacement in Lighting Systems.
    15. Fig 5: Removing/Installing Left I/P Access Cover
    GM796605Courtesy of GENERAL MOTORS CORP.
  15. Install the left I/P access cover.
    16. Fig 6: Removing/Installing HVAC Control Module Wire Harness Attachment
    GM828216Courtesy of GENERAL MOTORS CORP.
  16. Install the HVAC control module wire harness attachment (1) to the I/P substrate.
  17. Install the HVAC control module. Refer to HVAC Control Module Replacement in HVAC Systems-Manual.
  18. Install the radio. Refer to Radio Replacement in Entertainment.
  19. Install the I/P cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
  20. Install the I/P cluster bezel, Chevrolet only. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet)  or Bezel Replacement - Instrument Panel (I/P) Cluster (GMC/Oldsmobile/Buick) .
  21. Install the I/P accessory trim plate, GMC or Oldsmobile only. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC)  or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Oldsmobile/Buick) .
  22. Install the I/P lower sound insulator, GMC or Chevrolet only. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower (GMC/Chevrolet) .
  23. Install the center console. Refer to Console Replacement .
  24. Install the shift lever bezel, Oldsmobile only. Refer to Console Shift Lever Bezel Replacement (Oldsmobile, Buick) .
  25. Install the I/P compartment door. Refer to Door Replacement - Instrument Panel (I/P) Compartment .
  26. Install the right closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Right .
  27. Install the steering column. Refer to Steering Column Replacement in Steering Wheel and Column.
    28. Fig 7: Removing/Installing Left Side HVAC Floor Air Outlet Duct
    GM735934Courtesy of GENERAL MOTORS CORP.
  28. Install the left HVAC floor duct (1).
  29. Install the left HVAC floor duct push pin (2).
  30. Install the knee bolster. Refer to Knee Bolster Replacement .
  31. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  32. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
  33. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 and to SIR Disabling and Enabling Zone 5 in SIR.
scientia non olet · About LEMON Manuals