LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Closeout/Insulator Panel Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Closeout/Insulator Panel - Left
    GM712800Courtesy of GENERAL MOTORS CORP.
  1. Remove the 2 screws that retain the insulator panel to the instrument panel (I/P).
  2. Release the insulator panel retaining clip from the I/P substrate.
  3. Lower the insulator panel.
    4. Fig 2: Removing/Installing DLC At Closeout/Insulator Panel - Left
    GM865707Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2 data link connector (DLC) retaining screws.
  5. Remove the DLC from the insulator panel.
  6. Remove the splice pack from the insulator panel.
  7. Remove the hazard and turn signal flasher from the insulator panel. Refer to Hazard and Turn Signal Flasher Replacement in Lighting Systems.
  8. Remove the insulator panel from the I/P.
scientia non olet · About LEMON Manuals