LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Closeout/Insulator Panel Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing DLC At Closeout/Insulator Panel - Left
    GM865707Courtesy of GENERAL MOTORS CORP.
  1. Position the insulator panel to the I/P.
  2. Install the hazard and turn signal flasher to the insulator panel. Refer to Hazard and Turn Signal Flasher Replacement in Lighting Systems.
  3. Install the splice pack to the insulator panel.
  4. Position the DLC to the insulator panel.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the DLC retaining screws.

    Tighten:  Tighten the DLC retaining screws to 2.5 N.m (22 lb in).

    6. Fig 2: Installing Closeout/Insulator Panel Tabs To Cowl Slots - Left
    GM712807Courtesy of GENERAL MOTORS CORP.
  6. Install the insulator panel tabs to the cowl slots.
    7. Fig 3: Removing/Installing Closeout/Insulator Panel - Left
    GM712800Courtesy of GENERAL MOTORS CORP.
  7. Raise the insulator panel to the I/P.
  8. Install the insulator panel retaining clip to the I/P substrate.
  9. Install the 2 screws that retain the insulator panel to the I/P.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals