LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Bracket Replacement - Console Floor >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Block the wheels to prevent the vehicle from moving.
  2. Remove the floor shift control knob. Refer to Floor Shift Control Knob Replacement in Automatic Transmission.
  3. Remove the center console. Console Replacement 
  4. Disconnect the automatic transmission range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement in Automatic Transmission.
    5. Fig 1: Identifying Console Floor Bracket
    GM741605Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the automatic transmission shift interlock solenoid.
  6. Disconnect the electrical connector from the park brake.
  7. Remove the console bracket from the vehicle, by removing the retaining nuts (1) from the center instrument panel (IP) bracket.
  8. Remove the forward retaining screw, if equipped.
  9. Remove the remaining fasteners from the console bracket.
  10. Remove the console bracket from the vehicle.
  11. Remove the floor shift control. Refer to Floor Shift Control Replacement in Automatic Transmission.
scientia non olet · About LEMON Manuals