LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Fuel Tank >> Removal (Rear Tank On Dual Tank Models)

Removal (Rear Tank On Dual Tank Models)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Drain as much fuel as possible through fuel filler opening using a hand-operated pump or equivalent. Lower and remove spare wheel/tire. Raise and support vehicle. Remove spare tire rear crossmember.
  2. Disconnect fuel feed and return line fittings near front of rear fuel tank. See FUEL LINE DISCONNECT FITTINGS . Disconnect EVAP pipe near front of fuel tank. Cap fuel and EVAP lines to prevent possible fuel system contamination.
  3. Disconnect fuel sending unit and fuel pressure sensor harness connectors. Disconnect fuel fill pipe ground strap. Loosen fuel fill pipe hose clamp. Disconnect fuel fill hose at rear fuel tank. support rear fuel tank. Remove rear fuel tank strap bolts. Remove rear fuel tank straps. Remove rear fuel tank.
scientia non olet · About LEMON Manuals