LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine Controls - Removal, Overhaul & Installation) >> Emission Systems & Sub-Systems >> EVAP Canister Purge Solenoid >> Removal (4.8L, 5.3L & 6.0L)

Removal (4.8L, 5.3L & 6.0L)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen retaining bolt on intake manifold sight shield at top of engine. See Figure. Remove intake manifold sight shield from top of engine.
  2. Push retaining tab inward while pulling up on EVAP canister purge solenoid pipe connection to disconnect EVAP canister purge solenoid pipe from EVAP canister purge solenoid. EVAP canister purge solenoid is located near top right front of engine. See Figure.
  3. Disconnect EVAP canister purge solenoid harness connector. Remove EVAP canister purge solenoid retaining bolt. Remove EVAP canister purge solenoid and isolator from intake manifold.
scientia non olet · About LEMON Manuals