Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle): Removal

WARNING: This page does not describe the selected car, but rather 46 other vehicles, including the 2001 Pontiac Montana, 2001 Pontiac Aztek, 2001 Oldsmobile Silhouette, 2001 Oldsmobile Bravada, and 2001 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.

Remove rear hub and rotor assembly. See REAR BRAKE ROTOR . Using a long drift and hammer, drive out inner bearing race, inner bearing and oil seal from outboard to inboard side of hub.
Remove retaining ring from inside of hub, inboard of outer bearing. Using handle and outer bearing race remover/installer, drive out outer bearing race from outboard to inboard side of hub.