LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle) >> Installation

Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle): Installation

WARNING: This page does not describe the selected car, but rather 46 other vehicles, including the 2001 Pontiac Montana, 2001 Pontiac Aztek, 2001 Oldsmobile Silhouette, 2001 Oldsmobile Bravada, and 2001 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and pack bearings with wheel bearing lubricant. Using handle and bearing race installer, drive outer wheel bearing race into hub from inboard side of hub (ensure chamfered edge of bearing race installer is facing upward so that it does not contact bearing race).
  2. Install retaining ring on inboard side of outer bearing race. Turn hub and rotor assembly inboard side down. Using outer bearing race remover/installer, seat outer bearing race against retaining ring.
  3. Using inner bearing race remover/installer, drive inner bearing race into hub from inboard side of hub. Install inner bearing. Install new oil seal using axle shaft seal installer.
  4. To complete installation, reverse removal procedure. To adjust wheel bearings, see REAR BRAKE ROTOR .
scientia non olet · About LEMON Manuals