LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Parking Brake Shoes (Rear Disc Brakes) >> Removal (2500)

Removal (2500)

WARNING: This page does not describe the selected car, but rather 46 other vehicles, including the 2001 Pontiac Montana, 2001 Pontiac Aztek, 2001 Oldsmobile Silhouette, 2001 Oldsmobile Bravada, and 2001 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and the wheel.
  3. Remove the caliper and mounting bracket as an assembly.
  4. Relieve the tension on the park brake cables by loosening the nut at the equalizer.
  5. Remove the parking brake cable from the lever.
  6. Remove the rotor.
  7. Remove the axle shaft. See AXLE SHAFT article in DRIVE AXLES.
  8. Remove the park brake shoe return springs (4 and 6). See Figure
  9. Remove the park brake shoe anchor spring clips and pins (3).
  10. Remove the park brake shoes (2).
scientia non olet · About LEMON Manuals