LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Front Brake Caliper >> Installation

Front Brake Caliper: Installation

WARNING: This page does not describe the selected car, but rather 46 other vehicles, including the 2001 Pontiac Montana, 2001 Pontiac Aztek, 2001 Oldsmobile Silhouette, 2001 Oldsmobile Bravada, and 2001 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove caliper sleeves from caliper. See Figure. Apply silicone grease to outer diameter of caliper sleeves and inner diameter of bushings. Insert caliper sleeves into bushings.
  2. Install retainer spring on inner pad (if removed). Install pads in caliper. Install caliper. Install guide pins and tighten to specification. See TORQUE SPECIFICATIONS .
  3. Connect brake hose to caliper and tighten to specification. See TORQUE SPECIFICATIONS . Bleed brake system. See MANUAL BLEEDING  or PRESSURE BLEEDING  .
  4. If outer pads are equipped with locking ears, bend ears toward caliper until ears touch caliper. This prevents movement of outer pad in caliper. See Fig 1.
Fig 1: Bending Outer Pad Ears Toward Caliper
G91I13506Courtesy of GENERAL MOTORS CORP.


  1. Lubricate sleeves and bushings with silicone lubricant. Install NEW "O" rings to caliper. Install caliper mounting bolt sleeves. See Figure. Install brake linings. Install caliper mounting bolts. On "S" & "T" models, bend outer pad ears toward caliper. See Figure.
  2. To complete installation, reverse removal procedure. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS . Bleed brake system. See MANUAL BLEEDING  or PRESSURE BLEEDING  .
scientia non olet · About LEMON Manuals