LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Cancel Cam and Upper Bearing Thrust Washer >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Turn Signal Cancel Cam & Inner Race
    GM330130Courtesy of GENERAL MOTORS CORP.
  1. Install the following to the steering shaft:
    1. Inner race (1)
    2. Upper bearing inner race seat (2)
    3. Upper bearing spring (3)
    4. Turn signal cancel cam assembly (4)
    5. Shaft lock shield (5)
    2. Fig 2: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
    GM338052Courtesy of GENERAL MOTORS CORP.
  2. Install a new bearing retainer onto the steering shaft assembly.
  3. Compress the cam orientation plate using J 23653-SIR  and J 42137  to install the new bearing retainer. See Special Tools and Equipment .
  4. Remove J 23653-SIR  and J 42137  from the steering shaft assembly.
    5. Fig 3: Wave Washer & Steering Shaft
    GM293252Courtesy of GENERAL MOTORS CORP.
  5. Install the wave washer (1) onto the steering shaft assembly (2).
  6. Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals