LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Theft Deterrent Lock Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Electric Park Lock & Ignition Lock Cylinder Case Assembly
    GM368489Courtesy of GENERAL MOTORS CORP.
  1. Snap the electric park lock (2) onto the ignition lock cylinder case assembly (1).
  2. Fig 2: Removing/Installing Connector From Lock
    GM389654Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Inflator Module Coil Caution in Cautions and Notices.
  3. Reconnect the connector (2) to the electric park lock (1).
  4. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.