LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the steering wheel to the steering wheel shaft.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Removing/Installing Steering Wheel Retaining Nut
    GM731652Courtesy of GENERAL MOTORS CORP.
  2. Install the retaining nut that secures the steering wheel to the steering wheel shaft.

    Tighten:  Tighten the retaining nut to 41 N.m (30 lb ft).

    3. Fig 2: Removing/Installing Horn Plunger
    GM731656Courtesy of GENERAL MOTORS CORP.
  3. Connect the steering wheel electrical connector.
  4. Install the horn plunger to the steering column.
  5. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals