LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Tilt Head Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Steering Shaft
    GM667564Courtesy of GENERAL MOTORS CORP.
  1. Install the steering shaft (1) into the steering column tilt head assembly.
  2. Fig 2: View Of Upper Steering Column Components
    GM420224Courtesy of GENERAL MOTORS CORP.
  3. Install the steering shaft (3) into the steering column tilt head assembly (1).
  4. Install the tilt head assembly (1) and the steering shaft (3) into the steering column jacket assembly (2).
  5. IMPORTANT: The steering wheel lock shoes teeth must be resting on the bar in the steering column jacket assembly.
  6. Align the steering column tilt head assembly with the pivot pin holes on the steering column jacket assembly.
  7. Fig 3: Identifying Pivot Pin Locations
    GM420225Courtesy of GENERAL MOTORS CORP.
  8. Lubricate the pivot pins with GM P/N 12346293 (Canadian P/N 992723).

    Install the 2 pivot pins into the steering column support assembly.

  9. Stake the pins in 3 places.
  10. Install the tilt spring assembly only. Refer to Tilt Spring Replacement .
  11. Install the turn signal switch housing only. Refer to Multifunction Turn Signal Switch Housing Replacement .
  12. Install the turn signal and multifunction switch assembly only. Refer to Multifunction, Turn Signal Switch Replacement .
  13. Install the ignition lock cylinder case assembly. Refer to Ignition Lock Cylinder Case Replacement .
  14. Install the steering column to the vehicle. Refer to Steering Column Replacement .
  15. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.