LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install steering column seal by rolling seal lip to inside vehicle.
  2. Connect the lower intermediate shaft to the upper intermediate shaft.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Steering Column To Steering Gear Connection
    GM687445Courtesy of GENERAL MOTORS CORP.
  3. Install the lower intermediate shaft to the upper intermediate shaft pinch bolt.

    Tighten:  Tighten the lower intermediate shaft to the upper intermediate shaft pinch bolt to 50 N.m (37 lb ft).

    4. IMPORTANT: The upper intermediate shaft boot must completely cover the white insert of the lower intermediate shaft boot to ensure proper sealing.
  4. Connect the upper intermediate shaft boot to the lower intermediate shaft boot.
    5. Fig 2: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  5. Unlock the steering column by removing J 42640  from the steering column lower trim cover access hole.
scientia non olet · About LEMON Manuals