LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Column Assembly
    GM731644Courtesy of GENERAL MOTORS CORP.
  1. Install the steering column to the vehicle and connect the column to the intermediate shaft.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the steering column mounting nuts.

    Tighten:  Tighten the nuts to 27 N.m (20 lb ft).

  4. Fig 2: View Of Steering Column & Upper Intermediate Shaft
    GM731631Courtesy of GENERAL MOTORS CORP.
  5. Install the intermediate shaft bolt to the steering column.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  6. Fig 3: Removing/Installing Left Side HVAC Floor Air Outlet Duct
    GM735934Courtesy of GENERAL MOTORS CORP.
  7. Connect the left HVAC floor duct temperature sensor and install the left HVAC floor duct (1).
  8. Install the mounting screw (2) to the left HVAC floor duct.

    Tighten:  Tighten the screw to 1.9 N.m (17 lb in).

  9. Fig 4: Disconnecting/Connecting Steering Column Connector
    GM731648Courtesy of GENERAL MOTORS CORP.
  10. Connect the body wiring harness connector to the steering column lower bracket.
  11. Connect the steering column electrical connector to the vehicle wiring harness.

    Tighten:  Tighten the screw to 6 N.m (53 lb ft).

  12. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  13. Install the steering wheel. Refer to Steering Wheel Replacement .
  14. Unlock the steering column by removing J 42640  from the lower trim cover access hole.
  15. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.